What are the advantages of Terminal Block rows? As an important accessory, the terminal block has been well used in many electrical equipment, so what are the advantages of the terminal block? The reliability of capacitors in various equipment in the substation is relatively weak, the insulation between E and other equipment with ribbon voltage J is light and weak, and the internal components generate a lot of heat and poor heat dissipation. UKWire Connection is suitable for the interconnection of a large number of wires. In the power industry, there are special terminal blocks and terminal boxes, which are full of terminal blocks, single-layer, double-layer, current, voltage, common, breakable, etc. A certain crimping area is to ensure reliable contact and to ensure that sufficient current can pass. Terminals With the increasing degree of industrial automation and stricter and more precise industrial control requirements, the amount of terminal blocks is gradually increasing. With the development of the electronics industry, the use of terminal blocks is increasing, and there are more and more types. The terminal block is used to facilitate the connection of wires. It is actually a piece of metal sealed in insulating plastic. There are holes at both ends for inserting wires, and there are screws for fastening or loosening. For example, two wires, sometimes If they need to be connected, sometimes they need to be disconnected. At this time, they can be connected with terminals, and they can be disconnected at any time without having to weld them or twist them together, which is very convenient and quick. The possibility of internal failure of the capacitor is relatively high, and the internal material of the capacitor is a large combustible material, which is easy to catch fire during use. Therefore, the operation of power capacitors should create good low temperature and ventilation conditions as much as possible. The advantage of the terminal block is that it is convenient for the connection of the wires. It is actually a piece of metal sealed with insulating plastic, with holes at both ends for inserting wires, and screws for fastening or loosening. For example, two wires sometimes need to be connected and sometimes need to be disconnected. When they can be connected with a terminal block, they can be disconnected at any time without having to weld or twist them together, which is very convenient and fast. And it is suitable for the interconnection of a large number of wires. In the power industry, there are special terminal blocks, terminal boxes, all the above terminal blocks, single layer, double layer, current, voltage, common, easy to break, etc. A certain crimping area is to ensure reliable contact and to ensure that sufficient current can pass. Advantages of Terminal Connector: 1. Large wiring capacity, able to adapt to various wiring requirements. 2. The clamping frame is mechanically decoupled from the welding pin, that is, because the clamping frame and the welding pin are not connected as a whole, the torque when tightening the screw will not be transmitted to the soldering point. 3. The welding needle is quadrangular, and the end shrinks and becomes thinner obviously. Increased contact footprint when inserted into solder holes. The soldering fluid is easy to dissolve into the soldering hole, and it is not easy to make a false soldering. 4. The needle is copper alloy, free from dirt, ensuring long-term reliability of welding. 5. Tin-plated solder pins for easy soldering. 6. With heat dissipation channel. 7. The tip of the welding needle shrinks for easy installation. Therefore, the advantages of the terminal block are very obvious, and it is a good choice for people and is loved by people.
