The wiring terminals we install outdoors are relatively concealed, and the possibility of being directly hit by lightning is very small, but not complete, because some Wire Connections are always connected to the device at one end. The Terminal Block is used to facilitate the connection of wires. It is actually a piece of metal sealed in insulating plastic. There are holes at both ends for inserting wires, and there are screws for fastening or loosening. For example, two wires, sometimes If they need to be connected, sometimes they need to be disconnected. At this time, they can be connected with terminals, and they can be disconnected at any time without having to weld them or twist them together, which is very convenient and quick. UK terminals are suitable for the interconnection of a large number of wires. In the power industry, there are special terminal blocks and terminal boxes, all of which are terminal blocks, single-layer, double-layer, current, voltage, ordinary, breakable, etc. . A certain crimping area is to ensure reliable contact and to ensure that sufficient current can pass. Terminal block is an accessory product used to realize Electrical Connection, which is industrially divided into the category of connectors. So it will also be affected by lightning strikes, so we need to be absolutely safe, so how should we install the terminal blocks to make the lightning protection effect good. 1. We have strict requirements on the installation of Terminal Connector. If it does not meet the standards, it cannot be used, so we need to grasp the source. And there must be a clear understanding of the procurement and use of certain terminal blocks, so as not to go out of the edge due to quality problems in operation. 2. It is necessary to understand some relevant information of the equipment used by the enterprise, such as power capacity, etc., so that we can choose the terminal blocks that meet the actual situation, so that the safety technical performance can be effectively improved. 3. When we install the Electrical Connection system, we need to analyze and process the social contact surfaces, such as grinding and applying conductive paste. The purpose of this is to make the boundary terminals and lead clips in good contact and reduce the risk of heating problems in patients. Appear. 4. There are no obstacles around the terminal line, and the wires should be checked frequently to reduce the occurrence of injuries.
